[Oracle] Oracle创建带有参数的视图代码介绍

/* 按个人需要定义，我定义三个参数 ，因我项目程序需要，所以三个参数都是number ，当然可定义其它类型
但切记，第二个create 的参数类型等需以第一个create一致，否则程序包创建失败
*/
create or replace package p_view_param is 
  --参数一
  function set_param(num number) return number; 
  function get_param return number;
  --参数二
  function set_Type(num number) return number; 
  function get_Type return number;
  --参数三
  function set_Id(num number) return number; 
  function get_Id return number;
  end p_view_param; 
--
 create or replace package body p_view_param is 
  paramValue number; 
  paramType number; 
  paramId number; 
  -- Param
  function set_param(num number) return number is 
  begin 
   paramValue:=num; 
   return num; 
  end; 
  function get_param return number is 
  begin 
   return paramValue; 
  end; 
  -- Type
  function set_Type(num number) return number is 
  begin 
   paramType:=num; 
   return num; 
  end; 
  function get_Type return number is 
  begin 
   return paramType; 
  end;
  -- ID
  function set_Id(num number) return number is 
  begin 
   paramId:=num; 
   return num; 
  end; 
  function get_Id return number is 
  begin 
   return paramId; 
  end;
  end p_view_param;

/*
*定义视图，where 后面跟参数，可自己拼装，注意视图字段要和select的字段匹配
*/
CREATE OR REPLACE VIEW abstract_sum_view(fa_id, aircraft_num,aircraft_weight,airline_code,anchor_pos)
    AS SELECT f.fa_id, f.aircraft_num,findweight(f.aircraft_num),f.airline_code,f.anchor_pos
    FROM tb_flight_abstract f
     where f.fa_id=p_view_param.get_Id(); --参数
--使用视图，传参
 select * from abstract_sum_view where p_view_param.set_id(3)=3 ;